Muff Boost

A Beginner's Project I wanted to do a simple project that would be easy and cheap for a beginner to build. A good single transistor design can do the job well. Let's just extract a section of the classic Big Muff, modify it slightly and use it as a single booster stage. It can provide over 30db of gain and will be fairly low noise.
If D1, D2 and C3 are not used, the circuit will amplify without distorting. This is useful in overdriving a tube amp input as a clean boost or providing a boost to a weak guitar signal. When the diodes and capacitor are added, the circuit will become a simple distortion box.
The transistor is not too critical. Use the 2N3904, 2N2484, 2N5088, BC108 or similar NPN silicon devices. When used as a distortion, the 10uF/C3 capacitor controls high content to some extent. Make it smaller to add some brightness or leave it as shown for full range. The diodes may be replaced with germanium types for a different clipping response though I would use 4 diodes (2 pairs) to keep the output volume at a higher level.
The circuit is laid out on the pcb so that you can follow the schematic to visualize how the design goes together. The dpdt switch can be eliminated and the jacks connected to the pcb IN and OUT if you do not need to be able to switch the booster out of the signal path.
You can build the Muffer (as a boost without the diodes) on the AMZ Multi-Purpose PCB. Order one of these boards and build this easy project!
Muffer Schematic
Muffer Board Layout
Order a PC Board
 Referensi  http://www.muzique.com/schem/projects.htm